Too much noise of the bottom line machine

Date:2024-09-30 Click:0

The outsole threading machine is a device for sewing the bottom of shoes in the shoe industry, and it is one of the devices that many shoe manufacturers can't do without. This kind of equipment will make noise after it has been used for a long time. So where does this noise come from? How to deal with it?

Vibration analysis of the bottom line machine

In fact, the main reason for the noise of the big bottom thread machine is that its service life is too long, which makes the meshing height of the bevel gear of its internal transmission part inconsistent. Usually, after this happens, the firmware is replaced directly, or the tapping stick is used to reset it. Fastening the fasteners.

In addition, the noise caused by the axial looseness between the upper and lower shafts is handled. This kind of noise only needs to be re-adjusted after loosening the fastening screws.

If the above methods still cannot make the noise of your equipment disappear, it is recommended to directly replace with new parts. The product is durable and the quality far exceeds some equipment on the market. It is a good helper for shoemaking.

PREV:What is the bottom thread machine used for, and precautions for purchase

NEXT:Introduction to the precautions for the use of Yinma internal line machine, comm

Relevant Products:

Relevant News:

Too much noise of the bottom line machine

99999999免费网站

Focus on the research and development of shoemaking machinery for 41 years

Schematic diagram of equipment sewing position

You can directly click on the pattern to link to related machinery

Products

News

Contact US